Realistic Animatronic Dinosaur Manual
Ultimate guide on how to use our animatronic dinosaur step by step
Any problem with how to install, how to operate the animatronic dinosaurs?
We will walk you through on this page.
1. How to Load & Unload
In this video, you will see how we load our animatronic dinosaurs into the container.
Basically, a crane or forklift is required.
After loading the container, it goes to the destination port.
Here’s how to unload the animatronic dinosaurs.
A forklift is recommended.
2. How to Install
Step 1: Lift up the giant dinosaur and turn around the base.
Step 2: Install the leg steel, and tighten the screw.
Step 3: Put on the “SKIN”.
Step 4: Repair the skin and paint the color
3. How to Operate
Step 1: Prepare the control box, infrared sensor, speaker, and wires.
Step 2: Connect the infrared sensor, speaker, and power cable to the control box.
Step 3: Turn on the power. The dinosaur starts to move automatically. As easy as connecting one TV set.
4. How to Set Control Box
Step 1: Connect WiFi and search the IP “192.168.4.1”.
Step 2: Click the “FileManger” to import new sound files.
Step 3: Set the run time of the “PowerOn” area.
Step 4: Click “Save” after each change.
5. How to Repair Skin
Step 1: Tools request: Silicone, Elastic Silicone Skin, Scissor, Silk Stockings, Needlework.
Step 2: Put the elastic silicone skin into the damaged part.
Step 3: Use the needle and thread to sew up the broken skin.
Step 4: Brush one layer of silicone on the skin.
Step 5: Glue a small piece of silk stockings.
Step 6: Mix gasoline and silicone (20:1) and brush it on the silk stockings.
6. Paint the Color
Step 1: Tools request: Gasoline, Silicone, Water Scoop, Paint.
Step 2: Put the paint, silicone, and gasoline into the water scoop.
Step 3: Mix them up.
Step 4: Dip the mixture on the skin.